Rongge

I quite like the look of the Noisy Cricket Mk II amp from Beavis Audio (http://www.beavisaudio.com/projects/NoisyCricket/), and I happened to have a wooden box lying around that looked like it would work great as a 6” speaker cabinet, hence today’s project. (EDIT: Actually it turns out the Mk I and the MK II are the same. The only difference is the PCB design, and since I'm using veroboard, that's irrelevant.) The Noisy Cricket is a little 1/2 Watt guitar amplifier that fits into a standard Hammond-like enclosure (such as the one I used here: http://diystrat.blogspot.com/2013/04/building-modified-ea-tremolo-pedal-on.html). It uses a MPF102 or a 2N5951 transistor as a preamp channel and an LM386 as the power amp. It’s also powered from a standard 9v guitar pedal power supply (or even a battery). What’s not to like? As I usually do, I’m going to use Veroboard for this. A few people have already done layouts for it, and I decided to go with this one: Which can be found here: htt...

 This is an IC Based Amplifier circuit. This is Using Lm1895N Mini Amplifier Circuit Diagram. This circuit with 3-V to 9-V supplies, this amplifier can provide from 100-mW to 1-W output into a 4 and bandwidth is approximately 20 kHz @ 3 dB. This circuit is useful for low-power and battery applications. Drain is 80 mA @ 3 V or 270 mA @ 9 V at maximum signal conditions. Using Lm1895N Mini Amplifier Circuit Diagram

This circuit provides an un-interrupted power supply (UPS) to operate 12V, 9V and 5V DC-powered instruments at up to 1A current. The backup battery takes up the load without spikes or delay when the mains power gets interrupted. It can also be used as a workbench power supply that provides 12V, 9V and 5V operating voltages. The circuit immediately disconnects the load when the battery voltage reduces to 10.5V to prevent deep discharge of the battery. LED1 indication is provided to show the full charge voltage level of the battery. miniature white LEDs (LED2 and LED3) are used as emergency lamps during power failure at night. A standard step-down transformer provides 12V of AC, which is rectified by diodes D1 and D2. Capacitor C1 provides ripple-free DC to charge the battery and to the remaining circuit. When the mains power is on, diode D3 gets forward biased to charge the battery. Resistor R1 limits the charging current. Potentiometer VR1 (10k) with transistor T1 acts as the voltage c...

This Lepai Tripath-based audio amplifier is ideal in favor of both domestic and car audio applications. Its minor size and clean 20 watt output makes it finish for largely one sedan otherwise home audio project or DIY request everyplace area is restricted. This special buy Lepai Tripath-based mini audio amplifier is ideal in support of both abode and car audio applications. The TA2020 is a 20W/ch uninterrupted regular two-channel order-T Digital Audio Power Amplifier IC using Tripath's proprietary machinery.